DIYForums.org

Just ordered almost everything last night. Few thing on the BOM I could not find at Digikey or Mouser.. This will be my thread on the build and I hope not too may dumb questions on my part regarding the build

I have read a ton regarding all the Millett amp versions but if anyone has any up front advice I gladly listen

Aaron

I'm about half way through the bard population now, but I'm starting to get confused on a few things regarding QB8L/R and QB9L/R. I have not found these parts yet online but I'm trying to figure out where they go and where the little caps go.

Is there a construction thread for the MOSFET-MAX that I cant find? I read through the build on this site for the maxed but its different and on the older layout board.

Just trying to avoid as many mistakes as I can up front

Link to my picture gallery with the parts vendors and build process..
http://www.aalelan.com/gallery3/index.p ... MOSFET-MAX

Thanks!!

I installed all my Mouser parts this evening, and figure out what all I was missing / ordered wrong So the last order went into Mouser and www.alliedelec.com .

Seems I always order things I really really want on holiday weekends but I knew I would not build this Rome in a day

Check out the gallery link in my sig to see all my pictures!!!

Aaron

Refer to this page:
http://www.diyforums.org/MOSFET-MAX/MOS ... osfets.php
It pretty much defines what's different between the BJT MAX and the MOSFET-MAX. The only thing not included are the relays and switching at the inputs where the board-mounted DAC will go. Also, there's a reference photo at the bottom of that page that looks like this:

Not yet, but the techniques are the same - just pay attention to the different BOM and silkscreen for the new PCB.